Magnetek Enrange CAN-6 Technical Information PDF herunterladen (Seite 15)

Enrange MHR Instruction Manual

August 2014

Page 14 of 57

Figure 04: MHR with Con1 and Con2 connectors Figure 05: MHR Side View

2.3 INSTALLATION

1. Determine the location of your antenna from Figures 01-03 (antenna is designated

with red arrow). Be sure to mount receiver antenna in direct line-of-sight of

operator and free from all obstructions.

2. Do not mount receiver near high levels of electric noise, such as an unshielded

variable frequency drive, as it may cause minor interference.

3. Allow adequate room for mounting the receiver. Make sure to allow a minimum of 5”

between connector and nearest surface to allow for cable harness connections.

4. For best reception and to help protect connectors from moisture and water damage,

mount the receiver in an upright position. Mount with back flush against a flat surface

to protect vents from spray.

5. If obstructions can’t be cleared, or unit must be mounted inside a metal enclosure, the

remote antenna should be used (see Figure 01).

6. Do not enclose antenna in steel. For best reception, keep all metal objects away from

the antenna. Consult the factory for more information regarding your

application.

7. When mounting the receiver the unit should be torqued no more than 10-12 in-lbs.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Keine Kommentare

Magnetek Enrange CAN-6 Technical Information Seite 15