Magnetek Flex 12RS System Technical Information PDF herunterladen (Seite 16)

Flex M Engineered Receiver Instruction Manual

October 2014

Page 16 of 49

Figure 5. GEN1 High Power RF/CPU Module Detail View

(For RF/CPU modules 900MHz 1W (25-02-074-807E) & 900MHz 200mW (25-02-074-815E) only)

The dip switches are used to set the channel and to set relay output type. The dip switches can be

accessed by removing the module from the rail (see Section 3.8 for details on how to remove the

modules from the rail). After removing the RF/CPU module from the din rail, press in the tabs to release

the PCB from the housing (see Section 3.8 for details) and set the dip switches as necessary for the Flex

M system utilized. There are no wires to attach to the RF/CPU module aside from either an antenna or a

coaxial cable on the TNC antenna connection.

For channel dip switch settings for each of the different RF types, refer to the appropriate table in Section

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 48 49

Keine Kommentare

Magnetek Flex 12RS System Technical Information Seite 16