Magnetek Flex 12RS System Bedienerhandbuch PDF herunterladen (Seite 23)

Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual

April 2012

Page 23 of 42

Figure 19: Example of Flex M Receivers Mounted in an Enclosure

7.2. RECEIVER INSTALLATION

1. Be sure to mount the receiver antenna in direct line-of-sight of the operator and free from all

obstructions.

2. Do not mount the receiver near high levels of electric noise, such as an unshielded variable

frequency drive, as it may cause minor interference. When mounting the Flex M near unshielded variable

frequency drive, Magnetek typically recommends that the Flex M and all antenna cable routing be

mounted a minimum of 24 inches from all unshielded variable frequency drives and cables.

3. Allow adequate room for mounting the receiver. Make sure to allow a minimum of 5” between the

connector and nearest surface to allow for cable harness connections.

4. For best reception and to help protect connectors from moisture and water damage, mount the

receiver in an upright position. Mount with back flush against a flat surface to protect vents from spray.

5. If obstructions cannot be cleared, or the unit must be mounted inside a metal enclosure, the

remote antenna should be used (see Figure 19).

6. Do not enclose the antenna in steel. For the best reception, keep all metal objects away from the

antenna. Consult the factory for more information regarding your application.

7. The supply power to the Flex M system must have a master disconnect and should be fused.

8. The Flex M modules are installed on a 35mm din rail. To install the individual modules on the din

rail, hook the bottom of the module on the din rail and swing the top of the module to the rail until a click is

heard or felt.

9. After the modules are placed on the rail, they are slid together so they nest together. Rail clamps

are suggested to prevent the module bundle from sliding freely on the rail.

10. Modules MUST be installed so that the RF/CPU module is on the left end of the rail and the

power supply module is on the right end of the rail.

NOTE: Magnetek strongly recommends the use of external fuses and circuit disconnects for all Flex

Modules. Consult factory for more information.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Keine Kommentare

Magnetek Flex 12RS System Bedienerhandbuch Seite 23