Magnetek Flex 12EX System Bedienerhandbuch PDF herunterladen (Seite 35)

Flex 12EX System Instruction Manual

December 2013

Page 35 of 48

4.2.4.2 Non-Interlocked Functions

Contrary to interlocked settings, non-interlocked settings allow the two adjacent push

buttons to be used simultaneously. Non-interlocked settings are usually applied to a crane’s

auxiliary functions such as lights, horns, 3

speed, auxiliary stop, and Pitch & Catch. Each

dip-switch on the decoder module corresponds to one (1) motion or two (2) adjacent push

buttons (left & right push buttons).

Function

Code

Dip

Position

Setting

Dip Position Setting

#2 - #4 (left button)

#5 - #7 (right button)

Function Description

A 1 000

Normal (momentary) contact.

B 1 001

Toggled (latching) contact.

C 1 010

Acceleration (3

speed).

D 1 011

Toggled (latching) contact affected by the

E-Stop command. When E-Stop command

is initiated, all toggled (latching) relays are

also deactivated.

E 1 101

Pitch & Catch Type-1. When Pitch (release)

function is initiated, receiver MAIN will

not be deactivated.

F 1 110

Pitch & Catch Type-2. When Pitch (release)

function is initiated, receiver MAIN will

be deactivated.

G 1 111

Auxiliary Stop.

H 1 100

Normal + Start function. For added safety,

you must first rotate and hold the power key

switch at “START” position and then press

the intended push button at the same

time to activate the output relay.

Example #1: Left button (set to function code A) / right button (set to function code A) → 1 000 000

Example #2: Left button (set to function code B) / right button (set to function code B) → 1 001 001

Example #3: Left button (set to function code A) / right button (set to function code C) → 1 000 010

Example #4: Left button (set to function code F) / right button (set to function code A) → 1 110 000

Note: When set to Pitch & Catch function make sure the 2

transmitter is set to the next upper channel. For

example, if the system is preset at Ch.01 then the 2

transmitter should be set to Ch.02. Furthermore, you

must also set the dip-switch on the receiving module (position #7 & #8) to “10” position (2-channel

scanning), please refer to page 33.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Magnetek Flex 12EX System Bedienerhandbuch Seite 35

Kommentare zu diesen Handbüchern