Magnetek Enrange CAN-6 Bedienerhandbuch PDF herunterladen (Seite 29)

Flex 8EX System Instruction Manual

December 2013

Page 29 of 44

Aux

STOP

41 32 65 87

4132 65 87

4231 7856

41 2 3 65 78

4.2.2.10 Auxiliary STOP Push Button Function

The auxiliary STOP function acts as a 2

emergency stop button. Other than by

emergency stop button and transmitter power key switch, the receiver MAIN is also

deactivated when this auxiliary stop push button is pressed (refer to page 31 on how to

set to this function).

4.2.2.11 Pitch & Catch Function

This function allows two operators to control one crane from opposite ends of a cross or

long travel (refer to page 31 on how to set to this function). When set to “Pitch & Catch,”

make sure the 2

transmitter is set to the next upper channel (channel X*+1). For

example, if the system is preset at “Ch.01” then the channel of the 2

transmitter should

be set to “Ch.02”. Furthermore, the dip-switch position #7 and #8 on the receiving module

should be set to “10”, as this will allow the receiver to scan only Ch.01 and Ch.02 (please

refer to the illustration below). On the other hand, since there are only 62 available

channels on the Flex system, the system preset at channel 62 is ineffective because the

transmitter cannot be set to Ch.63. If your system is preset at Ch.62 make sure to

change it to another channel.

4.2.3 Receiver Auto-Scanning Settings

Receiver Channel Dip-switch

↓

(1) → Scanning all 62 channels (manufacture preset)

For standard operation

(2) → Single fixed channel (channel X*)

Auto scanning function disabled

(3) → Scanning 2 channels only (channel X*, channel X*+1)

For Pitch & Catch, Tandem, and Random Access operation

with 2 receivers

(4) → Scanning 3 channels only (channel X*, channel X*+1,

channel X*+2)

For Random Access operation with 3 receivers

* Channel X → Channel set on the receiving module

Example: If the first 6 dip-switch positions on the receiving module is set to Ch.01

(“000000” or “000001”), when set to 2-channel scanning (type-3 above),

then the receiver will only scan Ch.01 and Ch.02.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Magnetek Enrange CAN-6 Bedienerhandbuch Seite 29

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messen, Testen & Steuern Magnetek Enrange CAN-6